[Federal Register Volume 65, Number 240 (Wednesday, December 13, 2000)]
[Rules and Regulations]
[Pages 77827-77829]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-31600]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF DEFENSE
48 CFR Parts 212, 225, and 252
[DFARS Case 2000-D301]
Defense Federal Acquisition Regulation Supplement; Domestic
Source Restrictions-Ball and Roller Bearings and Vessel Propellers
AGENCY: Department of Defense (DoD).
ACTION: Interim rule with request for comments.
-----------------------------------------------------------------------
SUMMARY: The Director of Defense Procurement has issued an interim rule
amending the Defense Federal Acquisition Regulation Supplement (DFARS)
to implement Section 8064 of the DoD Appropriations Act for Fiscal year
2001 and Section 805 of the DoD Authorization Act for Fiscal Year 2001.
These laws place restrictions on the acquisition of vessel propellers
and ball and roller bearings from foreign sources.
DATES: Effective date: December 13, 2000.
Comment date: Comments on the interim rule should be submitted to
the address shown below on or before February 12, 2001, to be
considered in the formation of the final rule.
ADDRESSES: E-mailed comments are preferred. Submit comments to:
[email protected]. Please cite DFARS Case 2001-D301 in the subject
line.
Respondents that cannot submit comments by e-mail may submit
comments to: Defense Acquisition Regulations Council, Attn: Ms. Amy
Williams, OUSD(AT&L) DP (DAR), IMD 3C132, 3062 Defense Pentagon,
Washington, DC 20301-3062; facsimile (703) 602-0350. Please cite DFARS
Case 2000-D301.
FOR FURTHER INFORMATION CONTACT: Ms. Amy Williams, (703) 602-0288.
SUPPLEMENTARY INFORMATION:
A. Background
This interim rule amends the DFARS to implement Section 8064 of the
DoD Appropriations Act for Fiscal Year 2001 (Public Law 106-259) and
Section 805 of the DoD Authorization Act for Fiscal Year 2001 (Public
Law 106-398). Section 8064 of Public Law 106-259 restricts the
acquisition of ball and roller bearings and vessel propellers to those
produced by a domestic source and of domestic origin. The restriction
does not apply to the purchase of commercial items, except ball or
roller bearings purchased as end items. Section 805 of Public Law 106-
398 extends the restriction on acquisition of ball and roller bearings
at 10 U.S.C. 2534 through fiscal year 2005.
This rule was not subject to Office of Management and Budget review
under Executive Order 12866, dated September 30, 1993.
B. Regulatory Flexibility Act
This interim rule may have a significant economic impact on a
substantial number of small entities within the meaning of the
Regulatory Flexibility Act, 5 U.S.C. 601, et seq. An initial regulatory
flexibility analysis has been prepared and is summarized as follows:
The objective of this interim rule is to protect the domestic
industrial base for ball and roller bearings and vessel propellers as
required by Section 8064 of Public Law 106-259 and 10 U.S.C. 2534. By
restricting foreign competition, the rule will benefit domestic small
business concerns that manufacture ball or roller bearings, bearing
components, vessel propellers, or vessel propeller casings. This rule
does not duplicate, overlap, or conflict with other relevant Federal
rules.
DoD has submitted a copy of the initial regulatory flexibility
analysis to the Chief Counsel for Advocacy of the Small Business
Administration. Interested parties may obtain a copy of the analysis
from the point of contact specified herein. Comments are invited. DoD
also will consider comments from small entities concerning the affected
DFARS subparts in accordance with 5 U.S.C. 610. Such comments should be
submitted separately and should cite DFARS Case 2000-D301.
C. Paperwork Reduction Act
The Paperwork Reduction Act does not apply because the rule does
not impose any information collection requirements that require the
approval of the Office of Management and Budget under 44 U.S.C. 3501,
et seq.
D. Determination To Issue an Interim Rule
A determination has been made under the authority of the Secretary
of Defense that urgent and compelling reasons exist to publish this
interim rule prior to affording the public an opportunity to
[[Page 77828]]
comment. This interim rule implements Section 8064 of the DoD
Appropriations Act for Fiscal Year 2001 (Public Law 106-259) and
Section 805 of the DoD Authorization Act for Fiscal Year 2001 (Public
Law 106-398). Section 8064 of Public Law 106-259 restricts the
acquisition of ball and roller bearings and vessel propellers to those
produced by a domestic source and of domestic origin. Section 805 of
Public Law 106-398 extends the restriction on acquisition of ball and
roller bearings at 10 U.S.C. 2534 through fiscal year 2005. Section
8064 of Public Law 106-259 became effective on August 9, 2000, and
Section 805 of Public Law 106-398 became effective on October 30, 2000.
DoD will consider comments received in response to this interim rule in
the formation of the final rule.
List of Subjects in 48 CFR Parts 212, 225, and 252
Government procurement.
Michele P. Peterson,
Executive Editor, Defense Acquisition Regulations Council.
Therefore, 48 CFR Parts 212, 225, and 252 are amended as follows:
1. The authority citation for 48 CFR Parts 212, 225, and 252
continues to read as follows:
Authority: 41 U.S.C. 421 and 48 CFR Chapter 1.
PART 212--ACQUISITION OF COMMERCIAL ITEMS
2. Section 212.503 is amended by revising paragraph (a)(xi) to read
as follows:
212.503 Applicability of certain laws to Executive Agency contracts
for the acquisition of commercial items.
(a) * * *
(xi) Domestic Content Restrictions in the National Defense
Appropriations Acts for Fiscal Years 1996 and Subsequent Years, unless
the restriction specifically applies to commercial items. For the
restriction that specifically applies to commercial ball or roller
bearings as end items, see 225.7019-2(b) (Section 8064 of Public Law
106-259).
* * * * *
3. Section 212.504 is amended by revising paragraph (a)(xxv) to
read as follows:
212.504 Applicability of certain laws to subcontracts for the
acquisition of commercial items.
(a) * * *
(xxv) Domestic Content Restrictions in the National Defense
Appropriations Acts for Fiscal Years 1996 and Subsequent Years, unless
the restriction specifically applies to commercial items. For the
restriction that specifically applies to commercial ball or roller
bearings as end items, see 225.7019-2(b) (Section 8064 of Public Law
106-259).
* * * * *
PART 225--FOREIGN ACQUISITION
225.7019-1 [Amended]
4. Section 225.7019-1 is amended in paragraph (a) by removing the
phrase ``fiscal year 2000'' and adding in its place ``fiscal year
2005''.
5. Section 225.7019-2 is amended by revising paragraph (b) to read
as follows:
225.7019-2 Exceptions.
* * * * *
(b) The restriction in 225.7019-1(b) does not apply to contracts or
subcontracts for acquisition of commercial items, except for commercial
ball and roller bearings acquired as end items.
6. Section 225.7019-4 is revised to read as follows:
225.7019-4 Contract clause.
(a) Use the clause at 252.225-7016, Restriction on Acquisition of
Ball and Roller Bearings, in solicitations and contracts, unless--
(1) The restrictions in 225.7019-1 do not apply or a waiver has
been granted; or
(2) The contracting officer knows that the items being acquired do
not contain ball or roller bearings.
(b) In solicitations and contracts that use simplified acquisition
procedures, use the clause with its Alternate I.
7. Sections 225.7020 through 225.7020-4 are added to read as
follows:
225.7020 Restriction on vessel propellers.
225.7020-1 Restriction.
In accordance with Section 8064 of the National Defense
Appropriations Act for Fiscal Year 2001 (Public Law 106-259), do not
use fiscal year 2000 or 2001 funds to acquire vessel propellers other
than those produced by a domestic source of domestic origin, i.e.,
vessel propellers--
(a) Manufactured in the United States or Canada; and
(b) For which all component castings were poured and finished in
the United States or Canada.
225.7020-2 Exceptions.
This restriction does not apply to contracts or subcontracts for
acquisition of commercial items.
225.7020-3 Waiver.
The Secretary of the department responsible for acquisition may
waive this restriction on a case-by-case basis, by certifying to the
House and Senate Committees on Appropriations that--
(a) Adequate domestic supplies are not available to meet DoD
requirements on a timely basis; and
(b) The acquisition must be made in order to acquire capability for
national security purposes.
225.7020-4 Contract clause.
Use the clause at 252.225-7023, Restriction on Acquisition of
Vessel Propellers, in solicitations and contracts for the acquisition
of vessels or vessel propellers, unless--
(a) An exception under 225.7020-2 is known to apply or a waiver has
been granted in accordance with 225.7020-3; or
(b) The vessels being acquired do not contain vessel propellers.
PART 252--SOLICITATION PROVISIONS AND CONTRACT CLAUSES
8. Section 252.212-7001 is amended by revising the clause date; and
in paragraph (a) by adding, in numerical order, a new entry ``252.225-
7016'' to read as follows:
252.212-7001 Contract Terms and Conditions Required to Implement
Statutes or Executive Orders Applicable to Defense Acquisitions of
Commercial Items.
* * * * *
Contract Terms and Conditions Required To Implement Statutes or
Executive Orders Applicable to Defense Acquisitions of Commercial Items
(Dec 2000)
(a) * * *
____252.225-7016 Restriction on Acquisition of Ball and Roller
Bearings (____Alternate I) (Section 8064 of Pub. L. 106-259).
* * * * *
9. Section 252.225-7016 is amended by revising the clause date and
paragraph (c)(1); and by adding Alternate I to read as follows:
252.225-7016 Restriction on Acquisition of Ball and Roller Bearings.
* * * * *
Restriction on Acquisition of Ball and Roller Bearings (Dec 2000)
* * * * *
(c)(1) The restriction in paragraph (b) of this clause does not
apply to ball or roller bearings that are acquired as components
if--
(i) The end items or components containing ball or roller
bearings are commercial items; or
[[Page 77829]]
(ii) The ball or roller bearings are commercial components
manufactured in the United Kingdom.
* * * * *
Alternate I (Dec 2000) As prescribed in 225.7019-4(b),
substitute the following paragraph (c)(1)(ii) for paragraph
(c)(1)(ii) of the basic clause:
(c)(1)(ii) The ball or roller bearings are commercial
components.
10. Section 252.225-7023 is added to read as follows:
252.225-7023 Restriction on Acquisition of Vessel Propellers.
As prescribed in 225.7020-4, use the following clause:
Restriction on Acquisition of Vessel Propellers (Dec 2000)
(a) Except as provided in paragraph (b) of this clause, the
Contractor shall deliver under this contract, whether as end items
or components of end items, vessel propellers--
(1) Manufactured in the United States or Canada; and
(2) For which all component castings were poured and finished in
the United States or Canada.
(b) The restriction in paragraph (a) of this clause--
(1) Does not apply to vessel propellers that are commercial
items; and
(2) For other than commercial items, may be waived upon request
from the Contractor in accordance with subsection 225.7020-3 of the
Defense Federal Acquisition Regulation Supplement.
(End of clause)
[FR Doc. 00-31600 Filed 12-12-00; 8:45 am]
BILLING CODE 5000-04-M